Selmech Supplies Dflow Crimpmaster Operating and troubleshooting help and advice

On this page you will find some guidance on how to operate and solve problems with your applicator should they arise.

We stock an extensive range of spare parts so if you are looking to replace a broken or lost part then give us a call 01722 413440 and we will get that to you as soon as possible.

If the problem is with the operation of the applicator then the following may enable you to solve/identify it yourself and if not help us with a diagnoses.

Please feel free to contact us by phone if you want to talk through any of the steps on here.

Video

Operating the Dflow Crimpmaster

This is a short video showing how to operate the Dlfow Crimpmaster setting the tonnes per hour being treated and the application rate of the additive. It also shows how to bring up the total litres of additive applied and how to re set that figure. There is also a word about the syphoning message.

Dflow Crimpmaster Set-Up Mode

A short video showing how to use the Dflow Crimpmaster set-up mode to change between operating in Auto or NFS. This is particularly useful if there is a problem with the flow sensor the applicator can be run in NFS mode.

In this mode the controller ignores the flow sensor and just operates the pump directly. The output of the pump is displayed in % drive to the motor, 000 to 100. In this mode it will be up to the operator to carry out their own calibration check. If operating the pump like this it is recommended to by-pass the flow sensor and connect the pump directly to the application point.